Specification To En 13852 1 General Purpose Offshore Cranes-Books Download

Specification to EN 13852 1 General purpose offshore cranes
08 Nov 2019 | 1025 views | 5 downloads | 19 Pages | 518.96 KB

Share Pdf : Specification To En 13852 1 General Purpose Offshore Cranes

Download and Preview : Specification To En 13852 1 General Purpose Offshore Cranes


Report CopyRight/DMCA Form For : Specification To En 13852 1 General Purpose Offshore Cranes



Transcription

Revision history
VERSION DATE AMENDMENTS
1 0 December 2018 Issued for publication
Acknowledgements
This IOGP Specification was prepared by a Joint Industry Project 33
Standardization of Equipment Specifications for Procurement organized
by IOGP with support by the World Economic Forum WEF
Disclaimer
Whilst every effort has been made to ensure the accuracy of the information
contained in this publication neither IOGP nor any of its Members past present or
future warrants its accuracy or will regardless of its or their negligence assume
liability for any foreseeable or unforeseeable use made thereof which liability is
hereby excluded Consequently such use is at the recipient s own risk on the basis
that any use by the recipient constitutes agreement to the terms of this disclaimer
The recipient is obliged to inform any subsequent recipient of such terms
This publication is made available for information purposes and solely for the private
use of the user IOGP will not directly or indirectly endorse approve or accredit the
content of any course event or otherwise where this publication will be reproduced
Copyright notice
The contents of these pages are International Association of Oil Gas Producers
Permission is given to reproduce this report in whole or in part provided i
that the copyright of IOGP and ii the sources are acknowledged All other rights are
reserved Any other use requires the prior written permission of IOGP
These Terms and Conditions shall be governed by and construed in accordance
with the laws of England and Wales Disputes arising here from shall be exclusively
subject to the jurisdiction of the courts of England and Wales
Supplementary Specification to EN 13852 1 General purpose offshore cranes
Foreword
This specification was prepared under a Joint Industry Project 33 JIP33 Standardization of Equipment
Specifications for Procurement organized by the International Oil Gas Producers Association IOGP with
the support from the World Economic Forum WEF Ten key oil and gas companies from the IOGP
membership participated in developing this specification under JIP33 Phase 2 with the objective to leverage
and improve industry level standardization for projects globally in the oil and gas sector The work has
developed a minimized set of supplementary requirements for procurement with life cycle cost in mind based
on the ten participating members company specifications resulting in a common and jointly approved
specification and building on recognized industry and international standards
This specification has been developed in consultation with a broad user and supplier base to promote the
opportunity to realize benefits from standardization and achieve significant cost reductions for upstream project
costs The JIP33 work groups performed their activities in accordance with IOGP s Competition Law Guidelines
November 2014
Recent trends in oil and gas projects have demonstrated substantial budget and schedule overruns The Oil
and Gas Community within the World Economic Forum WEF has implemented a Capital Project Complexity
CPC initiative which seeks to drive a structural reduction in upstream project costs with a focus on industry
wide non competitive collaboration and standardization The vision from the CPC industry is to standardize
specifications for global procurement for equipment and packages facilitating improved standardization of
major projects across the globe While individual oil and gas companies have been improving standardization
within their own businesses this has limited value potential and the industry lags behind other industries and
has eroded value by creating bespoke components in projects
This specification aims to significantly reduce this waste decrease project costs and improve schedule through
pre competitive collaboration on standardization This document defines the supplementary requirements to
recognized industry standard EN 13852 2nd Edition 2013 Cranes Offshore cranes Part 1 General purpose
offshore cranes which is indispensable for the application of this specification
Following agreement of the relevant JIP33 work group and approval by the JIP33 Steering Committee the
IOGP Management Committee has agreed to the publication of this specification by IOGP Where adopted by
the individual operating companies this specification and associated documentation aims to supersede
existing company documentation for the purpose of industry harmonized standardization
Page 1 of 16 S 617 December 2018
Supplementary Specification to EN 13852 1 General purpose offshore cranes
Table of Contents
Foreword 1
Introduction 3
2 Normative references 5
4 List of significant hazards 5
5 Safety requirements and or protective measures 5
5 2 Strength and stability 5
5 3 Equipment and components 6
5 4 Drive systems 7
5 6 Noise reduction 8
5 7 Access guards etc 9
5 8 Controls indicators and limiting devices 10
5 9 Protection systems 11
5 11 Spill protection 11
6 Verification of the safety requirements and or protective measures 11
6 3 Verification records 11
7 Information for use 12
7 1 Documentation 12
7 4 Marking 12
7 5 Component identification system 12
Annex C normative Environmental influences 14
C 7 Corrosion protection 14
Annex E normative Material selection 15
E 5 Welded structures 15
Bibliography 16
Tables
Table 6 Purchaser system identification items 13
Table 7 Manufacturer sub assembly identification items 13
Page 2 of 16 S 617 December 2018
Supplementary Specification to EN 13852 1 General purpose offshore cranes
Introduction
The purpose of this specification is to define a minimum common set of supplementary requirements for
procurement of general purpose offshore cranes to EN 13852 1 2nd Edition 2013 for application in the
petroleum and natural gas industries
This JIP33 standardized procurement specification follows a common document structure comprising the four
documents as shown below which together with the purchase order define the overall technical specification
for procurement
JIP33 Specification for Procurement Documents
Supplementary Technical Requirement
It is required to use all of these documents in conjunction with each other when applying this specification as
follows
IOGP S 617 Supplementary specification to EN 13852 1 General purpose offshore cranes
This specification is written as an overlay to EN 13852 1 following the clause structure of
the parent standard to assist in cross referencing the requirements Where clauses from the
parent standard EN 13852 1 are not covered in this specification there are no
supplementary requirements or modifications to the respective clause The terminology used
within this specification follows that of the parent standard and otherwise is in accordance
with ISO IEC Directives Part 2
Modifications to the parent standard defined in this specification are identified as Add add
to clause or add new clause Replace part of or entire clause or Delete
IOGP S 617D Datasheet for General purpose offshore cranes
This document provides project specific requirements where the supplementary specification
and its parent standard require the user to define an application specific requirement It
follows the clause structure of the parent standard and this specification It also includes
information required by the user for technical evaluation Additional purchaser supplied
documents are also listed in the datasheet to define scope and technical requirements for
enquiry and purchase of the equipment
Page 3 of 16 S 617 December 2018

.


Related Books

iCAST: A PROTOTYPE THUNDERSTORM NOWCASTING SYSTEM FOCUSED ...

iCAST A PROTOTYPE THUNDERSTORM NOWCASTING SYSTEM FOCUSED

as grids, areas, lines, points, and time links. Aurora also ingests NWP (currently the Canadian GEM and US RUC models), high-resolution satellite data, radar data (Canadian and US), surface station observations, and lightning network data. iCAST employs a three-stage approach to nowcasting. First, NWP model output, past weather, current

P4.19 GEM-LAM CONVECTIVE FORECASTS: HOW CAN THEY BE USED ...

P4 19 GEM LAM CONVECTIVE FORECASTS HOW CAN THEY BE USED

2. MODEL CONFIGURATIONS The operational Canadian Global Environmental Multi-scale model (hereafter GEM15) is a four-dimensional variational data assimilation model (Gauthier et al. 2007) with a 15-km horizontal resolution (Mailhot et al. 2006). The operational GEM Limited Area Model (LAM) uses a horizontal resolution of 2.5 km. The physics and ...

Unit 4 Road Safety

Unit 4 Road Safety

traffic rules, there will be no accident! In this Unit, you will understand the various types of road safety measures to be adopted, and the importance of safety rules, road signs, traffic signals and rules, driving rules, registration and licensing adopted in our country. SESSION 1: IMPORTANCE OF ROAD SAFETY Road Safety

CANADA - United Nations Environment Programme

CANADA United Nations Environment Programme

newer model versions intended to continue this task. The currently running simulation using CMAM covers 1960-2050+ as part of the latest SPARC/WMO assessment. Stratospheric chemistry has also been coupled to a version of the Canadian Global Environmental Multiscale Model (GEM) for weather forecasting extended to 0.1 hPa. This has been done for ...

E 87 012-e 10-05 E6-E10 - HEINZMANN

E 87 012 e 10 05 E6 E10 HEINZMANN

1 Abbreviations Basic Systems E 6, E 6 V and E 10 1 1 Abbreviations E ..... Complete Basic System EA-KG ..... Flexible Mount for Control ...

Logistics in India: Challenges and Scope

Logistics in India Challenges and Scope

2.2.1 India-Emergence of Global Manufacturing Hub The demand for FMCG and electronic products in India has been growing at the very fast pace. Several MNCs from diverse industries have shown growing interest in setting up world class manufacturing facilities in India to cater to the domestic market as well as for the export market.

Interactive design of bonsai tree models - Algorithmic Botany

Interactive design of bonsai tree models Algorithmic Botany

Interactive design of bonsai tree models Frederic Boudon 1 Przemyslaw Prusinkiewicz 2 Pavol Federl 2 Christophe Godin 1 Radoslaw Karwowski 2 1 UMR Botanique et Bioinformatique de l'Architecture des Planes AMAP, Montpellier, France 2 Department of Computer Science, University of Calgary, Calgary, Alberta, Canada Abstract Because of their complexity, plant models used in computer graphics are ...

About the Author Exam Ref - pearsoncmg.com

About the Author Exam Ref pearsoncmg com

dozens of books on operating systems, networking, and PC hardware. He is coauthor of the Microsoft Training Kit for Exam 70-686 and author of

Bonsai Gardening Secrets

Bonsai Gardening Secrets

However, Bonsai is actually a way of growing many different species of trees. As you will learn later in this book, many different types of trees would make an excellent Bonsai such as Pine and Juniper. The key is learning which trees work best with what styles, as you will also learn. With Bonsai, the goal is to make the tree

PROGRAMME STANDARDS

PROGRAMME STANDARDS

Edition and the COPPA 2nd Edition, strategic directions of Malaysia Education Blueprint 2015?2025 (Higher Education) and Malaysia Higher Education 4.0 were also taken into account. The new mode of study and learning such as the 2u2i and WBL were also taken into consideration in reviewing the standards.